The creation of a bicycle trailer is a great advantage for every parent who loves to go for a nice bike ride. With a trailer bike, now you can go out to parents and children along and enjoy the ride. Most of the trailers can be easily assembled by placing a metal shaft. This guide explains how a trailer bike, easy to install.
Start by removing the rear wheel axle nut on the left side of the bike. There may be a release skewer on the right sideSide of the bicycle, which was released in order to loosen the nut on the left has. Drive to solve the cube on the left side of the bicycle. If you do not spit on the right side of the bike, then you need one, unscrew the nut key.
Most of the fans is a plastic washer. They range from plastic washer attached to the left and the trailer axle. This is just the right fit over the frame of the bike and should be about.
The next stepCoupling plates are provided. Place the coupling plate with the tabs on the back of the mounting holes directly into the washer. Once you put the clutch plate in the correct position, the big hole is sitting just below the axis.
At the end of the bridge, replace the motherboard. If you have a version of saliva, you will be able to mother with his hands. Once that is fixed, so make sure you close the lever on the right side of the bike. If you have notlock, you can position the nut with your hands, but you have to tighten with a key.
The end of the trailer is now ready to adapt to the big hole that is located on the fifth wheel plate. The rudder must be to ensure the safety pin at the bar. The safety pin attachment, or should go through the eye of the fifth wheel plate.
Take a seat belt, towbar and wraps around the frame tube was found. Must be positioned sovertical axis. The end of the tape should be on the D-ring-bars are two clips.
It seems difficult, but it is a quick process. Once installed, make sure everything is safe and secure. Then go out and enjoy the journey with your child!
| Price : $80.00
